I'm going to be doing my first custom watercooling loop soon and I was thinking of mounting the GPU vertically since my case has vertical mount built in. I got a riser cable but the case doesn't have any way of securing the riser so the whole card is just held on by the PCI slots. I kind of dig how it looks but my concern is that the the card sags a bit and is not perfectly straight. I've tried adjusting the screws on the slots but can't get it to be perfectly straight. The best I've gotten is that the end towards the front of the case is about 5mm lower and 10mm closer to the glass than the end screwed into the slots. The case is a be quiet Silent Base 601 if that helps.
Should I try to figure out a way of supporting the card better or will this be fine with hard tubing?
Should I try to figure out a way of supporting the card better or will this be fine with hard tubing?
Comment