Decided to rebuild my all-AMD home theatre rig back into (err onto?) a Core P3, and for a twist I did some sanding on the 16mm acrylic tube. It came out surprisingly decent, unless you look real close!
System specs for those who care:
Ryzen 3700x 8 core
Asus Crosshair VII Hero X470 motherboard / EK Monoblock
32GB (4 x 8GB G.Skill 3600 CL16 RAM (technically it's 3200/CL14, but runs at 3600/CL16)
AMD Radeon VII GPU / EK Vector GPU block
1TB ADATA SX8200 NVME SSD
2 x 2TB Micron SATA SSDs in RAID0
Asus WiFi card
ThermalTake Core P3 White Edition
Corsair AX850 850W PSU
Singularity Computers D5 pump top / reservoir
Alphacool UT60 420mm radiator, white edition
Fractal Design Prisma AL-140 PWM RGB fans
Barrowch flow meter / temp sensor
Darkside 16mm hard tube fittings / 90 degree fittings, white
16mm acrylic tube, lazily hand frosted by me with a 400 grit sanding pad
System specs for those who care:
Ryzen 3700x 8 core
Asus Crosshair VII Hero X470 motherboard / EK Monoblock
32GB (4 x 8GB G.Skill 3600 CL16 RAM (technically it's 3200/CL14, but runs at 3600/CL16)
AMD Radeon VII GPU / EK Vector GPU block
1TB ADATA SX8200 NVME SSD
2 x 2TB Micron SATA SSDs in RAID0
Asus WiFi card
ThermalTake Core P3 White Edition
Corsair AX850 850W PSU
Singularity Computers D5 pump top / reservoir
Alphacool UT60 420mm radiator, white edition
Fractal Design Prisma AL-140 PWM RGB fans
Barrowch flow meter / temp sensor
Darkside 16mm hard tube fittings / 90 degree fittings, white
16mm acrylic tube, lazily hand frosted by me with a 400 grit sanding pad
Comment