Rads after heat sources?

[Cheers!]

If you have 2 radiators and 2 major heat sources... (GPU and CPU).

Is there a benefit to diverting the hot water after the CPU then to the rad, and then go into the GPU and then into a rad and back into the CPU?

The pic below is what I'm thinking of.

[DazMode]

The temp variation within loop is 1c. Water moves too fast to make any difference.

[bungwirez]

oh, cripes.. sorry cheers, you made a thread yesterday that I didn't realize went unapproved. hope the guys can give you good advice on this one.

[Cheers!]

haha... no worries. I thought perhaps there was an error when I submitted the original thread. All I'm awaiting for is for Dazmode to get some stock of stuff before I pull the trigger. That and NCIX has been slow shipping me the Phenom case. I wanted to take some measurements and perhaps template up the rads and fan dimensions to see everything fits.

Hopefully the EKWB - EK-D5 X-RES 140 CSQ - Acetal D5 Top-Reservoir Combo comes back into stock. I'm not sure if the AquaComputer - Aqualis PRO 450 ml + the pump block + the D5 pump will fit the case. When all 3 of them are installed together it's pretty tall.

[DazMode]

Hopefully the EKWB - EK-D5 X-RES 140 CSQ - Acetal D5 Top-Reservoir Combo comes back into stock. I'm not sure if the AquaComputer - Aqualis PRO 450 ml + the pump block + the D5 pump will fit the case. When all 3 of them are installed together it's pretty tall.

EK has no stock for a while. I'm trying to get one with pump already pre-installed.

[Cheers!]

Dazmode: Can you get the DDC version? Does EK have stock?

[DazMode]

Dazmode: Can you get the DDC version? Does EK have stock?

I have thsi one: https://www.dazmode.com/store/product/ek-ddc_100_csq/