Liberty

[snef]

yes and I love it, I used it for Dark Aura and Clear sky: city of angel and more I work with it more complicated thing I do

for melting issue, I had the same, be sure you keep paper on both side of the panel, of if like me you have plexi with plastic film, put green tape where you cut, now I have a very clean cut

I have some 3/4" thick acrylic here and tried a lot of time to cut it and always melt, after EZ told me this trick, I make cut who look like laser cut

[EZ's PC's]

yes and I love it, I used it for Dark Aura and Clear sky: city of angel and more I work with it more complicated thing I do

for melting issue, I had the same, be sure you keep paper on both side of the panel, of if like me you have plexi with plastic film, put green tape where you cut, now I have a very clean cut

I have some 3/4" thick acrylic here and tried a lot of time to cut it and always melt, after EZ told me this trick, I make cut who look like laser cut

ya I didnt give you the tough love like jp told me.....use WD40 and got my moto-saw all slimey hahaha. If you need to make cuts on acrylic without film, say like a piece of scrap acrylic. Use painters tape over your where you intend to cut and a lot cleaner than sprayin wd40 all over the place. Curse you JP hahaha

[JPModified]

Hehehehe.

[nass]

Ya seen your build log on youtube, very nice work Jp, she should be proud for sure, liked the aging you did on it also, came out nice.