Look at Darkside pre-sleeved wires

[10e]

Hey now

MoAR colours!

https://www.dazmode.com/store/catego...ved-diy-wires/

So far we have white,black,green,orange

I'm assuming these are 4mm sleeved Daz?

Look great, and thank you for getting these in right when I was going to start my first real sleeving project

[DazMode]

2mm, 4mm is too big for AWG18 wire.

Also those wires will be compatible with new closed combs.

[10e]

2mm, 4mm is too big for AWG18 wire.

Also those wires will be compatible with new closed combs.

Bazinga, that's what I wanted to know. Thanks DAZ

[Hooded]

Closed combs!!!
Do you have an eta on those?

[DazMode]

Closed combs!!!
Do you have an eta on those?

as soon as I finish posting them in store...

[Hooded]

as soon as I finish posting them in store...

[snef]

question about pre-sleeved cable, what a time saver, like these a lot

any possibilities to have double wire pre-sleeve? all PSU have 2 to 4 double wire

[10e]

Hey snef, what PSUs have you seen lately with double wires?

I'll check my PSUs and see if there are any, and I have the Corsair and EVGA Cablemod kits and will get a look at those for you.

Daz: Are the new cable combs up on the site under cable mgmt section? I quickly looked and saw some clear and black closed ones.

Thx!

[DazMode]

question about pre-sleeved cable, what a time saver, like these a lot

any possibilities to have double wire pre-sleeve? all PSU have 2 to 4 double wire

I had one y-cable on my AX1200, which I ignored (only used one feed) and everything works great.

Sleeved Y-cable wont look good and most likely requires heat shrink, which will ruin everything.

[DazMode]

Daz: Are the new cable combs up on the site under cable mgmt section? I quickly looked and saw some clear and black closed ones.

Thx!

All combs are in the same section (both open (original model) and closed (new arrival))

[snef]

seasonic, evga and corsair I sleeved have all 4 double wire

only Silverstone don't have double wire, maybe others but never sleeved one

[DazMode]

seasonic, evga and corsair I sleeved have all 4 double wire

only Silverstone don't have double wire, maybe others but never sleeved one

Do you remeber if two wires were on pSU end or Mobo? It seems for em they just fill empty holes on PSU end...

[snef]

the double wire is on PSU,
ex: EVGA have a 10 and 18 pin connector on PSU

one double wire for 3.3, one for 5v and one for ground

maybe your right, just not sure if I will remove double wire and use only single from one or other

[bungwirez]

this is excellent.

My burnt finger tips thank you very much Daz.

[DazMode]

I will ask Corsair about those wires.

So far my Sentinel works great after ignoring double wire from pin 13.