Dazlab test results

[DazMode]

Here is first video from Dazlab Reloaded project:

[Cyclops]

Nice job.

1150 RPM EK fan Way too loud.

[Bartacus]

Nice job.

1150 RPM EK fan Way too loud.

Word bro. 50+ DBs for an 1150rpm fan is nuts. Nice job Daz!

[Hooded]

Good info for sure. Test needs to be on rads as Daz states. Would be nice to see how low the voltages can go as well, and the actual start up voltages

[DazMode]

Word bro. 50+ DBs for an 1150rpm fan is nuts. Nice job Daz!

Note that I did 15cm, while manufacturers like to measure 25 or even 35cm away. I feel that as I don't have sound insulated room, it would better if I get closer to object, but far away to keep air movement from affecting measurement.

[nass]

i find I run my fans on low speed, but even if I run on high speed I get no change in temps maybe is because am running 2-360 rads that fan speed is not relevant to temp changes, not sure...
Thx for testing out the new rad fans Daz, always good to know which are the loudest.

[RicMX3]

Good info, i'm a little disapointed for the noise, gentle typhoon are still beter, at least for low RPM and it's what i'm looking for...

Good info for sure. Test needs to be on rads as Daz states. Would be nice to see how low the voltages can go as well, and the actual start up voltages

+1, i also want to see these fan on a radiator against a GT. Daz, can you test a F1/F2/F3/F4 start up voltages / RPM and show us how low the voltage can go, if there any difference between the 4 models except the speed?

I'm looking for 16 fans for my setup (4 rads 480) low noise & rpm, but i wonder if i should buy F4 instead of F1/F2 and run them at low volt for low RPM operation while keeping the extra speed for benchs.

Thanks

[DazMode]

Updated noise profile video. Interesting to see .... errr hear side by side...

[bungwirez]

pretty much what I expected.

I didn't realize you were going to re test these fans.
I was going to suggest slapping them onto a rad with your darkside noise dampening strips.

[Bartacus]

GTs FTW! I should have bought about 12 more of those before they stopped making them!

[Hooded]

Save your cash for May Bart. Daz is getting some GT's in

[Bartacus]

Save your cash for May Bart. Daz is getting some GT's in

[DazMode]

Or if cannot wait, Coolerguys in USa still have stock.

[DazMode]

I did first round of tests to reconfirm min system requirements for cpu+gpu setup. Min dual radiator still stands as correct recommendation.

I will publish exact results as entire test is complete.