Next question?

[nass]

This next cpu block from aguacomputer has a thin 5 pin connection on the end of the cable from cpu block. What would I plug that into, ie: not an aquaro 5-6 idea, on my motherboard am referring too? Need an adapter?

[Hooded]

If Cuplex Kryos Next Vario with Vision is the block your talking about, then I think you need this PDF to properly explain hook up options of the VISION system
Vision

[DazMode]

USB I belive?

[nass]

Just looks so thin but yes is supposed to do water temp default without a 5 or 6 aqua.

[nass]

If Cuplex Kryos Next Vario with Vision is the block your talking about, then I think you need this PDF to properly explain hook up options of the VISION system
Vision

Hey Hooded I have the next vision. You know in the manual it says dick about the cable though but sometimes things get lost in the translation with AC I notice sometimes.

[nass]

[IMG][/IMG]

I know the pic sucks, have the vision cpu plugged into the left of the 2 pictured usb headers, this thing is only 1/2 the thickness of a normal usb, wiring on the one on the right looks simuler on the upper side but the left one from vision has 2 more black wires on the upper section that the usb on the right doesn't have.
Am hoping not to fry the display or my board with this, lol.
Sent a message to Shoggy on ocn hopefully he'll get back to me before I finish my bends lol. ( will not power it till I know for sure though)

[Hooded]

Look for a triangle on the connector. That should be pin #1 of the USB port.

[nass]

There is a small triangle on the red wire side

[nass]

Thx Hooded

[nass]

So my pic is right then pin one is to the left on my board

[nass]

[nass]

so am confused now seems it goes on the 4 pin lower section to be pin 1 ? yet connector is a 5 pin from AC.

[Hooded]

Aqua Computer USB Pin assignment.

Pin 1 not connected
Pin 2 GNO (black)
Pin 3 0+ (green)
Pin 4 0- (white)
Pin 5 +5 V (red)

Typical USB pinout has one pin not in use when only a half a connector is in use.

Go with the colours as the pins # seems to be for the Vision PCB not the header on the motherboard

[nass]

so the red on my AC connector should go how and where into my motherboard usb 2 header using the red wire as the reference?

[Hooded]

The Red is the 5-volt wire and has the triangle. Should be pin #1 on your mother board.