Tweet
Just run blocks in series, the blocks have very little restriction and at higher flow rates you will not see any difference in temps, like Hooded said match up back plate with same Man. if you can. Welcome to our forum ! 
-
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu -
I personally never find a much difference between serial and parallel set ups. In serial next card is barely 1 degree hotter.Originally posted by PerryC View Post
On backplates, answer is all over the place... Some do not even touch GPU pcb, while others come with thermal pads and actually dissipate some heat.__________________________________________________
Retro Build: Build Log,
Baby Blue Build: Build Log,
Green Lanten Build: Build Log,
Sentinel Build: Build Log,
Venom Build: Build Log,
Silent Sniper Build: Final Video,
Orange Build: Final Video
HTPC Build: Final Video
__________________________________________________Comment
-
I remember watching this video on youtube - its priceless
How would one go about priming their pump mate?
Originally posted by Hooded View PostPlease don't fill your loop like this idiot did.
Filling Water Loop Fail!
You think it might have been a good plan to prime the pump before he turned it on.| i7 3770k | Maximus V Formula | 2x Corsair Dominator Platinum 8gb @ 1866mhz (looking to replace with 16-32gb Dominator Platinum @2400mhz) | 2x XFX HD7950 Crossfire | 2x OCZ Vertex 3 Raid 0 | 2x WD 1TB Black Drives @7200rpm | 3x Asus 27" MX279H in eyefinity- 5760x1080 | Corsair HX1050 PSU | CM HAF 932 Case | - Hoping DAzMode will help me put all this under water.Comment
Comment