Overkill

[Necrodead]

Thats the glass res right? super beautiful but expensive to match.

Nice overkill parts!

[Overkill]

I felt I had to put something big in there as the SMA8 is such a large case. That or run dual res

[Overkill]

Ram ordered. 4x4g of Red C15 3000mhz DDR4 Corsair and 4x4g of Black C15 3000mhz DDR4 Corsair.

Need some opinions, Pastel Red or Blood Red coolant?

[Overkill]

And so begins my bad luck. Went to install my EK SLI bridge and two of the Helicoils (middle and right) on one of my EK Titan X block disintegrated. Got some coming in tomorrow from a local shop, fingers crossed.

[Father Fuzzy]

bummer

sounds like a hassle

[Overkill]

looks like the previous owner to these blocks may have stripped them, talked with EK and a new top is on its way. Seller covered the cost so the only thing I am out is time.

[Overkill]

Thanks for getting the case and res shipped quickly Daz! excited to start building!

[DazMode]

You are welcome, thank you for ordering this monster. Looking forward to see pics!

[Overkill]

Should be interesting as I have never tried hard line.

[DazMode]

Should be interesting as I have never tried hard line.

After two builds I just did, I'd say it was MUCH easier that I was imagining...

[Overkill]

PETG or acrylic?

[DazMode]

If you have time, I'd do acrylic.

[Necrodead]

Acrylic, its more transparent than the PETG and imo easier to work with in regards to sanding/finishing the ends.

[10e]

I also prefer acrylic.

PETG requires more sanding on the cut ends than acrylic because it's more of a "rubbery" plastic. It also doesn't have as good resistance to ethylene glycol as acrylic, so that might be a problem down the line, though I haven't seen anything posted on that yet.

[Overkill]

Thanks Daz! excited to start this one.