If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
on top of reservoir, EK have 3 ports on top and 2 on front of the top
inlet use one in front and share with one on top
I use another ports
and use this
I would say that, if the In/Out ports are on the same center as the holes for mounting screws, then yes it's reversible. Other wise no it won't be. If you remove the single terminal block from your current block you should be able to see if these are all inline.
Oh and I like it just the way you got it. Nice video
I would say that, if the In/Out ports are on the same center as the holes for mounting screws, then yes it's reversible. Other wise no it won't be. If you remove the single terminal block from your current block you should be able to see if these are all inline.
Oh and I like it just the way you got it. Nice video
I don't know if a FC-Terminal triple clear is a god idea on this
I really want to try it
this one
I need to know if I can put it up-side-own (ports are on top)
I think its a question for the new EK rep lol
Not sure about EK, but the WaterCool Multi-Links only fit one way, the ones I have used anyways. Look to see if there is a slot on one end for the PCB to seat.
EDIT: Just noticed that is a Tri-SLI block. If it has the slots I mentioned, there should be one for the middle card as well.
Comment