Hi guys,
I noticed the jet plate for the 1150 that comes with this water block has two small notches on the width side. Pictured below in the bottom left.
The installation instructions mention you need to make sure the plate 'locks into place' but don't speak to the correct orientation of those notches. What I mean is, the notches could be reversed just by flipping the jet plate over.
So my question is: Is there a correct orientation for this jet plate or does it matter? [EDIT] unless the notches correspond to posts in the block which create the 'lock'... ?
Thanks.
I noticed the jet plate for the 1150 that comes with this water block has two small notches on the width side. Pictured below in the bottom left.
The installation instructions mention you need to make sure the plate 'locks into place' but don't speak to the correct orientation of those notches. What I mean is, the notches could be reversed just by flipping the jet plate over.
So my question is: Is there a correct orientation for this jet plate or does it matter? [EDIT] unless the notches correspond to posts in the block which create the 'lock'... ?
Thanks.
Comment