I'm connecting my Darkside CONNECT LEDs, and I just wanted to make sure everything is going to work ok. I have some single LEDs, a couple of LED strips, I'm connecting them to Aqua Computer's SPLITTY9, and then to a Poweradjust Ultra so I can control the brightness. Some of the LEDs are connected using a 3 way splitter converting them all to 1 x 3 pin connector, 2 of the LEDs are connected using a 2 way splitter to 1 x 3 pin connector, and the strips are hooked up directly to the SPLITTY9 using a 2 pin to 3 pin cable. The SPLITTY9 will be powered from a Poweradjust Ultra.
I'm just wondering if these LEDs will work correctly when powered like this. I'm not sure if anyone has used a SPLITTY9 to power the Darkside LEDs since it's such a new device, but has anyone else hooked them all up to a splitter hub and/or cables or does anyone know if these will work the way I'm trying to wire them up? I would appreciate any advice or suggestions anyone might have.
I'm just wondering if these LEDs will work correctly when powered like this. I'm not sure if anyone has used a SPLITTY9 to power the Darkside LEDs since it's such a new device, but has anyone else hooked them all up to a splitter hub and/or cables or does anyone know if these will work the way I'm trying to wire them up? I would appreciate any advice or suggestions anyone might have.
Comment