If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
G , the bottom offset is about even with drain, works nice redid that length on that one to make it shorter after noticing it was pushing on my mb tray backing, it drained np.
Still hate the other tube run in his system really. May redo them here over the holidays.
Wife didn't understand what I bought him, X-mas morning she gets up and theres a white sma8 on kitchen table 830 in the morning parts lying around it on table.... ( was waiting for kid to open his present), should have seen the look I got..
Thought I was going to have too get Hooded to call the help line again for me this year.
Cool, must have been the angle of the shot, just some plumber trash-talk. lol Cheers
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Kevin got back to me over the holiday's from caselabs:
Thank you for contacting us!
In order to change the orientation of the SMA8, you will need to purchase the following SMA8 chassis sections in the orientation you wish to change to:
Front Chassis
SMA8 Rear Chassis
Top Chassis
Mid-Plate
SMA8 Chassis Divider
Think I will wait on this adventure... Especially since would need it in white.
Had to pull the motherboard out of my son's system, the Gigabyte z97 GT had some issues, no post, boot looping, generally just being a pita.
Pulled it and reinstalled the mb, redid all but one tube run on the loop. Used an older gigabyte oc force z87 board I had in previous systems. No complaints from the corner room yet.
Took the morning to redo, kid helped this time around. New runs cheated and used fittings come out nice though. No bending for a change.
Going to be replacing all the hardware in this case tomorrow.
Z270f strix board
I7-7700k
G.skill 3000 rgb ram
Existing msi 1070 is staying with the new setup
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Comment