On my 44 Magnum build I needed to paint the blades of 20 gentle typhoons ap-15's from the grey to red
First you heat up the label and peel it back
Then you see the tiny horseshoe clip holding the fan to housing
I tried to buy a proper spring clip tool but the smallest out there was too big for it
so I used 2 precision screwdrivers to undo the clip
out of the first 16 I lost 1 clip and broke 2
I quickly fiqured out I should have a massive magnet to help catch the jumping clips
and used a magnet tray to help and it worked great never lost any after that
Then you mask the fan spindles off
Then you start applying thin coats
this is 2nd coat
did about 6 coats on each side on this set of 10
Then remove masking and time to reassemble
Then sleeve the wires
Tip
When you are sleeving the wires with a heatgun dont have the power cord behind the box of fans
they will hit the floor and shatter
then u will need to go buy more and repeat the steps all over again
First you heat up the label and peel it back
Then you see the tiny horseshoe clip holding the fan to housing
I tried to buy a proper spring clip tool but the smallest out there was too big for it
so I used 2 precision screwdrivers to undo the clip
out of the first 16 I lost 1 clip and broke 2
I quickly fiqured out I should have a massive magnet to help catch the jumping clips
and used a magnet tray to help and it worked great never lost any after that
Then you mask the fan spindles off
Then you start applying thin coats
this is 2nd coat
did about 6 coats on each side on this set of 10
Then remove masking and time to reassemble
Then sleeve the wires
Tip
When you are sleeving the wires with a heatgun dont have the power cord behind the box of fans
they will hit the floor and shatter
then u will need to go buy more and repeat the steps all over again
Comment