If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
wet sanding with 2000 sand paper and use meguiar car compound polish pasts
no need a lot of sanding just a couple of minutes on each side (GPU and pam block need in and out side)
and polish with compound, this stpes need more time
this guy sont use wet sanding, it work but more easy with water and youy will not fill your sanding paper with residu
i use one strip of sanding paper pof 3" x 8.5" for all my block
Sweet looking blocks snef, wish I had time for details like that.
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Fantastic job on painting and polishing, feet look great in white !
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Feet are really cool. Block looks great as well. That how EK should have done it from the beginning.
exactly, what i dont like on EK block is the frost finish, when i saw we can polish it, i change for all Ek block
clear with cricle is better than clean ek block, IMO
Feet look awesome next to the red muscle car...incredible
Did you just mask around the rubber bottom on the feet?
Blocks look Super,nice work
Thanks FF
nope, paint the whole thing and the rubber bad have just a little gap to be able to remove the plasti-dip on it
i dont mask anything with Plasti-dip, cut and remove is faster
i doing the shield of my Xonar Phoebus and i have a small plexi at top for led, juste remove it and its perfect
That how EK should have done it from the beginning.
I know eh. for an extra 5 or 10 minutes of manufacture time... really so much better looking product.
would you up charge for a custom polish version out of the store?
i tried in 2 diferent case and same thing (caselabs M8 and LD PC-V4)
i cant lock the gpu in PCIe slot because the block on GPU sit on Motherboard water block screw......serious??????? why not use the same screw as the plate on GPU (Flat head screw)
pics
and same thing for the second card lolll
i dont have tools to modify tu use flat head screw
anyway
go to Update
some pics
start my loop today, i dont hink i will finish it this week but very close
ahh need to drill a larger hole for FannBlade Feet
more update soon
Comment