If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Temps 15c idle, 36c load under Prime with 16 threads rocking. This block really does its job big time. 5 x 120 rads, 600mm x 120mm rad surface area helps also. Fans are on the silent profile. Cpu is at 1.35 volts and 3.8 speed, 4.0 is too much for this chip.
Now did have one leak, first time have had one in hardtube, the res stops had to hit the end caps with the pliers to seal them by hand was not enough, Singularity needs to smooth out the threads a little better on the res and block tops some were really hard to tighten in. Other than that the parts are gorgeous plus the options on the outs.
Very nicely done nass.
Loving your tube runs as well.
Thx Hooded was a hard set of runs first was the bottom outlet to the first rad at the back that took some work to get it too line up and was hard to reach with pump outlet at the back, both rads are tight to each other also. Come out ok I think. It will change a bit once I get a vega. Will be some tight runs to the vid and res.
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Managed to get the cpu to 3.9 stable @1.3 volts was at 3.8 on the stock hsf.
Thats funny, my stock voltage was about 1.35v. Got it to 3.9 on that and 4.0 on 1.45v, but i dialed it back since that jump in voltage was so big. Good overclock tho, 3.9 @ 1.3v seems quite good.
3770K IHS removed-Max V gene-2x4gig ram Gskills 2400 Trident X-2x400watt Qmax TEC`s with dew point controller-420 Monsta rad for TEC hotside-360 TFC Xchanger for dual 670`s-RP452 res with 2xD5 vario pumps- HF Supreme with modified plate-DD Cp Pro pump for cold side of TEC and cpu block-Dual CM haf 922`s and a Seasonic X-1250 Psu
Thats funny, my stock voltage was about 1.35v. Got it to 3.9 on that and 4.0 on 1.45v, but i dialed it back since that jump in voltage was so big. Good overclock tho, 3.9 @ 1.3v seems quite good.
Ya was mistaken it is @ 1.35v was cpuz showing the abbreviated voltage, hwinfo shows 1.352 v. Ya the extra kick on the voltage is not worth the hundred usually, plus mine at least on air didn't like it even @1.4.
We had taco's G, cleaned up after posting that earlier today.
Comment